Almaty info@dji.pro Mon–Sat 09:00–18:00

DJI AL2 Spotlight

Dual spotlight for DJI Matrice 5T with flood and spot lights. Up to 10 lux at 100 m, Lighting and Strobe modes, IP55 protection.

Description

DJI AL2 — a spotlight for nighttime search and rescue and inspection of dark areas such as under bridges. It mounts on DJI Matrice 5T and follows the camera tilt from -90° to 90°, so the light always points where the camera is looking.

Two lights — flood and spot — deliver up to 10 lux center illuminance at 100 m and cover up to 1500 m². Strobe mode helps attract attention and mark the drone.

Key features

  • Flood and spot lights — up to 1500 m² and up to 10 lux at 100 m.
  • Lighting and Strobe modes — for search and marking the drone.
  • Follows camera tilt — from -90° to 90°.
  • 60 W power — at 175 g.
  • IP55 protection — operation in rain and dust.

Compatible devices

AL2 SpotLight

Weight175 g
DimensionsUnfolded: 200×78×58 mm (L×W×H)
Folded: 104×82×58 mm (L×W×H)
Max Power60 W
Max IlluminanceFlood: 2.5±0.3 lux@100 m*
Spot: 10.0±0.5 lux@100 m** The data was measured in a laboratory environment with the spotlight installed separately on the aircraft at an ambient temperature of 25° C (77° F).
Effective Illumination AngleFlood: 24.5° (10% relative illuminance)
Spot: 14.5° (10% relative illuminance)
Effective Illumination AreaFlood: 1500 square meters @100 m (10% relative illuminance)
Spot: 500 square meters @100 m (10% relative illuminance)
Operating ModeLighting, Strobe
Gimbal Mechanical RangeTilt: -170° to 120°
Gimbal Controllable Rotation RangeTilt: -90° to 90°
Operating Temperature-20° to 50° C (-4° to 122° F)
Ingress Protection RatingIP55** Please follow the requirements stated in the IP55 protection rating instructions. This product has been tested under controlled laboratory conditions and achieved an IP55 rating. IPX5 water-resistance test conditions: (1) nozzle internal diameter of 6.3 mm; (2) water flow rate of 12.5 L/min (±5%); (3) water pressure of approximately 30 kPa; (4) distance from the nozzle to the product: 2.5 to 3 m; (5) test duration of at least 1 minute per square meter of surface area, with a total duration of at least 3 minutes; (6) water sprayed onto the enclosure from all directions. IP5X dust-resistance test conditions: (1) dry, non-abrasive fine dust used as the test medium; (2) fineness sufficient to pass through a flat square-mesh sieve with a mesh aperture of 75 μm and a wire diameter of 50 μm; (3) dust concentration of 2 kg per cubic meter of test chamber volume; (4) test duration of 8 hours; (5) test conducted in a sealed dust chamber. The IP rating is not permanently effective and may decrease due to normal wear and tear.

Specifications are based on official DJI data (enterprise.dji.com/matrice-5t/specs). Actual values may vary depending on operating conditions and firmware version.